1.4m2 tests

[ronan]

I have been tested 1.4m2 a little ahead and found a few problems in the admin :
- the list of existing categories is not displayed in the "Category administration" section. But categories are displayed when creating a new FAQ entry
- I tried to add an attachment but I got a "You are not authorized" message, whereas I am the administrator
- I tried to check the rights in the user administration section. My rights are "1111111111111111111111" which looks like I have all rights. Anyway I couldn't find a way to edit these rights
- I editted an existing FAQ entry and changed its content. This entry was not changed: a new entry was created.
- I added a image link in a FAQ entry. I used a relative URL. It works well for public access, but the preview mode in the admin does not work (due to relative address)

Regards,

Ronan

[Thorsten]

Hi Ronan,

- the list of existing categories is not displayed in the "Category administration" section. But categories are displayed when creating a new FAQ entry

the category module got a rewrite since december.

- I tried to add an attachment but I got a "You are not authorized" message, whereas I am the administrator

I'll look at this issue.

- I tried to check the rights in the user administration section. My rights are "1111111111111111111111" which looks like I have all rights. Anyway I couldn't find a way to edit these rights

I'll look at this issue.

- I editted an existing FAQ entry and changed its content. This entry was not changed: a new entry was created.

I'll look at this issue.

- I added a image link in a FAQ entry. I used a relative URL. It works well for public access, but the preview mode in the admin does not work (due to relative address)

I'll look at this issue.

Please note that 1.4.0 M2 is a pre-alpha release!

thanks + bye
Thorsten

[ronan]

Please note that 1.4.0 M2 is a pre-alpha release!

That is very clear to me, I hope some feedback might help.

Anyway I really need a internationalized version now. Would you advice me to go with 14m2 with my changes (see my post in the forum) or to go with the latest 1.3 (what changes would be required then ?)

Thank you for your answer,

Ronan

[Thorsten]

Hi,

if 1.4.0 M2 is stable enough for you, you should use it, because the internationalization is better in the new version.

bye
Thorsten